NEW Raymarine AIS700 Class B AIS Transceiver with Antenna Splitter

The AIS700 from Raymarine is a Class B Automatic Identification System (AIS) transceiver designed for use with Raymarine multifunction navigation display systems. As a Class B AIS transceiver, the AIS700 not only receives broadcasts from other vessels, it also transmits your own boat’s information too helping you to be seen on other vessels’ systems.

AIS700 FEATURES

Full transmit and receive AIS for enhanced situational awareness and safety
Latest SO-TDMA networking for longer range and faster performance
Built-in antenna splitter simplifies installation with existing VHF radio antenna*
NMEA2000, NMEA0183, PC (setup & diagnostics) and SeaTalkng compatible.
Software or hardware switchable Silent Mode for enhanced security when needed

*See specifications table for more information.

AIS Targets Menu

AIS Contacts

AIS Radar Overlay

AIS700 SPECIFICATIONS

	GENERAL SPECIFICATIONS

Specifications | Ordering Information | What's In The Box

AIS700 SPECIFICATIONS

Expand All Close All	TECHNICAL SPECIFICATIONS

ENVIRONMENTAL SPECIFICATIONS

Operating temperature	-15°C to +55°C
Storage temperature	-20°C to +75°C
Water ingress	IPX6 and IPX7
Humidity	Up to 93% @ 40°C

POWER SPECIFICATIONS

Power Supply	12v and 24 nominal
Power Consumption	<3W
Peak current	3A
Load Equivalency Number	1 LEN

RF SPECIFICATIONS

DSC Receiver	Implemented by time sharing with one TDMA receiver
Receiver 1 band	156.025 MHz to 162.025 MHz (in 25KHz steps)
Receiver 2 band	156.025 MHz to 162.025 MHz (in 25KHz steps)
Transmitter band	156.025 MHz to 162.025 MHz (in 25KHz steps)
Transmitter specification	To meet IEC 62287-2 relevant sections
Receiver specification	To meet IEC 62287-2 relevant sections
Transceiver specification	To meet IEC 62287-2 relevant sections
GPS receiver	u-blox MAX-M8W
GPS receiver channels	72 channels
GPS Cold start acquisition time	26s nominal
Positional source	GPS & GLONASS
AIS performance	5W SOTDMA

ANTENNA SPLITTER SPECIFICATIONS

Operating frequency range	156.0MHz to 162.025MHz Transmitting 156.0MHz to 162.025MHz Receiving
Insertion loss AIS RX path	0dB
Insertion loss AIS TX path	<1dB
Insertion loss VHF RX path	0dB
Insertion loss VHF TX path	<1dB
Power handling AIS port	Maximum 5W input
Power handling VHF port	25W input
Switching time RX to VHF TX	10uS Max
Switching time RX to AIS TX	10uS Max
Switching time VHF TX to AIS TX	10uS Max
Switching time any TX to RX	10uS Max
VHF port impedance	50 Ohms
AIS port impedance	50 Ohms
Antenna port impedance	50 Ohms
VHF to AIS port isolation	>28dB (both directions)
Minimum VHF input power for switching	400mW

*To share a VHF antenna, the aerial should meet the following requirements (nominally tuned to 159MHz):

Frequency Band	156.025 MHz to 162.025 MHz
VSWR (Voltage Standing Wave Radio)	Should not exceed 2:1
Impedance	50 Ohm
Gain	3dBi Max
Connector	PL-259

EXTERNAL CONNECTIONS

VHF antenna connector type	SO-239 co-axial
VHF radio connector type	SO-239 co-axial
GNSS antenna connector	50Ω TNC co-axial
NMEA2000	DeviceNet male
USB	Micro-B
External interface isolation	NMEA0183 and NMEA 2000 interfaces to incorporate galvanic isolation from power supply as required by the relevant interface specification.
NMEA0183 interface 1 (MFD connection)	NMEA 0183 HS (IEC 61162-1) compliant, bi-directional, RS422 levels. 4 wire interface (differential signalling). Configurable baud rate. Input to MFD from AIS.
NMEA0183 interface 2 (NMEA0183 instrument connection)	NMEA 0183 (IEC 61162-1) compliant, bi-directional, RS422 levels. 4 wire interface (differential signalling). 4 wire interface (differential signalling) Configurable baud rate
USB interface (PC connection)	Protocol NMEA 0183 HS (IEC 61162-1) compliant, bi-directional USB port, 38.4 kBaud

AIS700 ORDERING INFORMATION

	ORDERING INFORMATION
Part Number	Description
E70476	AIS700 Class B Transceiver with integrated antenna splitter

AIS700 WHAT'S IN THE BOX

IN THE BOX
1	AIS700 Class B AIS Transceiver with built-in VHF antenna splitter
2	GNSS (GPS) Antenna with captive cable 10m (33 ft)
3	Power / data cable 2m (6.56 ft)
4	VHF Radio cable 1m (3.28 ft)
5	DeviceNet to SeaTalkng® adaptor cable 1m (3.28 ft)
6	GNSS antenna gasket
7	GNSS antenna pole mount
8	Unit fixings (4 x No.8x19 self tapping screws)
9	M5 nut and washer (grounding)
10	Documentation kit
11	GNSS antenna fixings (3 x M3x40 stud and thumb nut)